Kirill
1487308118
Kirill
1487308118
Posted 1496220610
#2
By the way. I had had a thought. Deoxygenation depends on time under loading and weight in % of a one-repeated maximum.
Therefore change (growth smo2) on standard warm-up scales in exercises without relaxation of muscles speaks about a hypertrophy of muscles. Also Moxy can be the control device.
bobbyjobling
1454439119
Posted 1496260858
#3
That is due to low fat content under the Moxy sensor, you need to move it to an area with more adipose fat.
Kirill
1487308118
Posted 1496286687
#4
Thickness of the fat over the whole area of the VL ~ 3 mm. It is possible to put on other quadriceps heads
bobbyjobling
1454439119
Posted 1496300047
#5
Try to move it more orizontaly towards RF but still keep it on VL. You will see a higher resting SmO2 when you get more fat under the sesnor.
Roger
Moderator
1340810797
Posted 1496323709
#6
This is an issue of the readings going off of the calibration lookup table. A slightly different location might help. The underlying issue is that there are factors in the tissue that the Moxy is not completely insensitive to. This could be things like skin color, inhomegeneities in the muscle, or any other factor that makes the light interact with the tissue differently than the model expects.
Kirill
1487308118
Posted 1496329442
#7
My skin is white, without sunburn. And in general, there is never a problem with reading except performing exercises without relaxing the muscles ("imitation" kaatsu).
Full-amplitude squat, during which the O2 level with a jump in the range from 0 to 18% does not cause disabling of data recording.
bobbyjobling
1454439119
Posted 1496329558
#8
You need more body fat
